Fish & Ski Seats (58" Rear Bench)

Fish & Ski Boat Seats w/ 58" Rear Bench Seat

• Driver and passenger side bass boat bucket seats
• 58" (3) piece rear bench seat
• Rear bench includes (2) 17" high back folding seats and (1) 24" center bench seat
• High back fold seats can be used as fishing seats
• All mounting hardware is included

Factory Grade Replacement Seats

• 6 year full replacement warranty on upholstery
• 32oz soft to the touch, marine grade seat vinyl
• Custom molded foam cushions won't break down
• Pinchless hinges are powder coated aluminum
• Heavy duty hold down straps will not stretch or fail
• Plastic frames with 100% stainless steel hardware
• All mounting hardware is included (stainless)

Protect your investment with our DeckMate Seat Cleaner and Protectant

Seat Dimensions

Instructions

Installing Your Boat Seats Hardware Included:

1. (8) Stainless steel mounting bolts pre-installed into t-nuts located on the bottom of the seat frame.

Note: DeckMate Bass Boat Bucket Seats Bolted Or Screwed Down To Your Seating Platform.

Screw Down Installation:

1. Ensure that there is not a fuel tank located beneath your seating platform.

2. Remove each bucket seat's cushion by locating and removing the two bolts that are on either side of the bottom frame of each bucket.

3. Once these bolts are removed you can pull the seat cushion off of the plastic frame. There are strips of industrial Velcro that also hold the cushion in place, pull hard on the seat cushion once the bolts are removed and it will come off.

4. Place each bucket seat in the mounting position. There are two opening in the seat frame (one on each side) that allow you to use a screw and washer to connect the bucket to your seating platform.

5. Install the bucket seat cushion by placing it back into the opening and pressing hard to secure the Velcro, this will hold the seat in place.

Bolt Down Installation:

Note: For those boats with lids that hinge forward you can bolt the bucket seats to your seating platform.

1. Located on the bottom of each bucket seat are (4) stainless steel bolts that are pre-installed into t-nuts that are built into the plastic frame of each bucket seat.

2. Remove these stainless bolts and place the bucket seat into the position you wish to mount it. Determine the mounting location and pre-drill holes through your lids.

3. Install the mounting bolts through your boat's lids and into the t-nuts located on the bottom of each bucket seats plastic frame.

Low Back Installation:

Installing Your Boat Seats

Hardware Included:

1. (4) stainless steel mounting bolts are pre-installed into the plastic seat bottom.

DeckMate Boat Seats Will Install On Any Pedestal Mount

1. Remove the temporary plastic edge protectors from the front corners of your new boat seat. These are installed to protect the fishing seats during storage and shipping. Simply pull the edges off the plastic protectors and pull the staples out, this will not hurt the boat seat.

2. Unscrew the (4) mounting bolts from under the boat seat's frame.

3. Install the pedestal seat mount to the bottom of the fishing seat's plastic frame using the bolts.

Note: Some pedestal seat mounts have a front, check your mount to insure it is installed properly. Also, start each mounting bolt by hand to prevent mis-threading of the t-nuts that are inserted into the bottom of the boat seat frame.